Ws332m2-5 Temperature & Humidity Transmitter

• Type: Wall-Mounted Current Type
• Measuring Medium: Temperature and Humidity
• Display Type: LCD
• Site Display: Site Display
• Accuracy: 0.5
• IP Rating: IP65
• Model NO.: HT001
• Certification: CCC
• Customized: Customized
• Usage: Outdoor
• Theory: Temperature Controller
• Working Voltage: DC12-24V
• Humidity Range: 0~100%Rh
• Transport Package: Anti-Static Bag Packaging, Pearl Cotton Protectio
• Trademark: JP
• Origin: Hefei, Anhui, China
• HS Code: 9025800000
• Production Capacity: 200kpcs /Year

Product Description

WS332M2-5 Temperature & Humidity Transmitter

♦ Wall mounting, 86 type shell, magnetically mounted,
LCD display
♦ Special circuit, high accuracy
♦ RS485 signal output, Modbus-RTU protocol
♦ Linearity responds, integrated temperature and humidity

TECHNICAL INFORMATION

	Temperature	Humidity
Measuring range	-20ºC ~ 60ºC	0% ~ 100%
Accuracy	≤±0.3ºC (at 25ºC)	≤±0.1%RH (25ºC, 30%RH~80%RH)
Stabilization	<0.1ºC/year	<1%RH/year
Response time	≤15s (1m/s)	≤4s (1m/s)
Output	RS485
Power supply	5V ~ 24V DC
Sensor	HT001
Power consumption	<240mW
Working	-20ºC~60ºC
Anti-surge voltage	±2000V
Storage temperature	-40ºC~80ºC (without condensation
Connection	RJ45 connector
Housing material	Engineering Plastics

wiring
Order of RJ45 connector: 1:V+   2:V-   3: 485A  4:485B

 Communication Protocol
 BAUD: 9600    8 data bits, no parity
 Board instructions

1. Temperature data show
2. Humidity data show
3. Other parameter show
4. Function button

Mounting and fix the product


General problem and solution
 The device cannot be connected to the PLC or computer 
  Possible reason:
 1) The computer has many COM ports, the choice of the port is not correct
 2) The device address is wrong, or the device with duplicate address exists (the factory default is all 1)
 3) Baud rate, check mode, data bit, stop bit error
 4) The host polling interval and wait time for reply are too short and need to be set above 200ms
 5) RS485 wiring be disconnected, or A,B wire be connected oppsitely.
 6) Equipment wiring is too long, or too much should be nearby power supply, plus 485 enhancer, at the same time an increase of 120Ω terminal resistance.
 7) USB transfer 485 driver not installed or damaged
 8) Equipment damage

Product dimension

NOTICE
 The mounting direction of soleplate should be attented. Avoid the following: close proximity of the transmitter to a heating element, a cold or hot wall, direct exposure to sun rays, etc.
 Be sure to cut off the power supply before mounting and changing transmitter.
 If the mounting surface with a large temperature difference between the measured environmental, recommend the use of stents installed more than 20cm away from the mounting surface.
It will be necessary to calibrate the transmitter when it is using above 12 month.